The LCD screen housing plate / brace is what keeps the LCD tight and secure within your PlayStation Portable Console. The picture below shows what the plate looks like when the actual LCD screen has been removed. There are seven screws that you need to remove to enable you to take off the housing plate. There are three screws along the top and four along the bottom.
Once you have undone these screws, you then need to gently pry the housing plate outwards, with a small Flathead screwdriver separate the tabs between the D-Pad (where the directional buttons would be if the faceplate was attached) and the LCD housing plate. Once this is done slide the UMD door latch over so the UMD door comes open, as before gently prise the LCD housing plate from your PSP console.
Once you have removed the plate, you will then have clear visibility of the MBO (Motherboard) as the picture shows above. From here you can then go on the fix / repair other parts of your PSP.
No comments:
Post a Comment